Place the plug end of your headphones under your middle and ring fingers. With your other hand, start wrapping the cord around your pointed fingers, crossing in the middle after each wrap. So, the cord will wrap around each finger from the same direction.
Is it bad to wrap your headphones?
Putting too much pressure on your wires by tightly folding and wrapping them, is sure to break your headphone in no time at all, as it will create pressure points that will eventually simply snap your cable.
How do you wrap your headphones without damaging them?
Instead of simply rolling like a ball of knitting yarn, earphones need to be loosely wrapped around fingers and woven in a manner that they neither get tangled nor are damaged. To do this, start wrapping the chord over your fingers. Be sure to leave out some length towards the end.
How do I keep my headphones in good condition?
8 Simple Tips To Take Good Care Of Your Headphones
- Clean your earbuds.
- Keep your earphones in a case.
- Unplug your earphones after use.
- Pull out the plug, not the cable.
- Don’t turn up the volume too high.
- Avoid sleeping with your headphones on.
- Don’t share your earbuds with other people.
Why do headphones break so easily?
The most common reasons why earbuds break so easily have to do with the following 7 factors: Pulling or tugging on the earbuds’ cords when disconnecting them. Leaving earphones dangling off tables, couches, beds, and other surfaces. Sleeping with your earbuds in, exposing them to twisting.
How can I make a headphone protector?
Cut socks in half at about the part where the ankle would be. If using thin socks, cut out some padding to match the dimensions of your headphones.
- Measure the dimensions of your old headphones.
- Cut shapes out.
- Turn shapes inside out.
- Turn right side out.
- Sew the retaining strap.
- Slide onto headphones.
How do you make a earbud holder?
If you want to create something simple, try using a credit card, clothespins, or a piece of fabric to make an easy wrap. For something a little sturdier, try an empty mint container as an earphone cord holder. Once you finish making your holder, your earbuds will stay organized and tangle-free!